Get a quote
Guide · Buying & choosing

What type of house do I have?

Knowing roughly when your house was built tells you how its walls work, which materials it needs and what tends to go wrong. The biggest difference is whether the walls are solid or have a cavity.

Georgian brick terraces with chimney stacks under a cloudy sky

In short

  • Houses built before about 1920 usually have solid brick walls laid in lime mortar.
  • Interwar houses can have solid walls or early cavity walls, so each one needs checking.
  • Most houses built since 1945 have cavity walls, and most built since about 1990 have insulation in the cavity.
  • Solid walls need breathable materials. Cavity walls have their own problems, such as corroded wall ties.

Solid wall or cavity wall: the quick test

Look at the pattern of the bricks. If some bricks are laid end-on, so you see their short ends in the wall, it is probably a solid wall. If every brick is laid lengthways, it is probably a cavity wall. If the wall is rendered, measure its thickness at a window or door: a brick wall more than about 260mm thick probably has a cavity.

Neither test is foolproof. Some cavity walls were built with half bricks to look solid. Dates below are approximate and overlap, and plenty of houses have been altered since.

Georgian and Regency, before about 1840

How to recognise it: a flat, symmetrical front, tall sash windows with small panes, often a parapet along the top hiding the roof, a fanlight over the front door. Regency houses often have a painted stucco ground floor or a fully stuccoed front, and iron balconies.

How it is built: solid brick walls in lime mortar, often in London stock brick, frequently with gauged brick arches over the windows. Roofs are often a hidden valley, or butterfly, behind the parapet.

What goes wrong: blocked or leaking valley and parapet gutters, cracked stucco, hard cement repairs on soft brick, and decayed timbers where water has got in unseen.

Victorian and Edwardian, about 1840 to 1914

How to recognise it: Victorian terraces and villas with bay windows, decorative brickwork, slate roofs, sash windows with larger panes and a back addition behind. Edwardian houses tend to be wider and more often red brick, with deep porches, timber-framed gables and casement windows.

How it is built: mostly solid brick walls in lime mortar, suspended timber ground floors ventilated by air bricks, and a fireplace in most rooms. Later houses may have a slate or engineering-brick damp-proof course. Some later ones have early cavity walls.

What goes wrong: worn pointing, chimney breasts removed without proper support, raised ground levels and blocked air bricks causing damp and rot, slipped slates, bay windows moving, and cement render or pointing trapping moisture.

1920s and 1930s

How to recognise it: semi-detached houses in pairs, two-storey bays, hipped tiled roofs, pebbledash or render, mock-Tudor gables and stained glass in the doors and windows.

How it is built: a mix. Cavity walls became more common between the wars, but plenty of houses were still built solid. Early cavity walls were tied together with mild steel ties and the cavity is uninsulated unless it has been filled since.

What goes wrong: rusting wall ties, which can show as horizontal cracks in the mortar joints at regular intervals, cracked render, leaking bay roofs, and original metal windows replaced badly.

Post-war, 1945 to the 1960s

How to recognise it: plainer houses, larger windows, concrete roof tiles, often shallower roofs. Many estates were built by councils.

How it is built: cavity walls had become standard, generally uninsulated when built. After the war, some houses were built using non-traditional systems such as precast concrete panels, and certain types were designated defective under the Housing Defects Act 1984.

What goes wrong: wall tie corrosion, flat roofs on extensions and garages, and, for non-traditional houses, concrete decay. Check the construction type before buying, as it can affect a mortgage.

Modern houses, 1970s onwards, and flats in converted houses

Modern houses have cavity walls, increasingly insulated from the 1970s and 1980s as building regulations tightened. Most built since about 1990 have insulation in the cavity. Roofs are usually prefabricated trussed rafters, which should not be cut or altered without an engineer. Problems are more often condensation, flat roofs and poor detailing than the walls themselves.

Flats in converted houses keep the problems of the original house, usually Victorian, plus a layer of paperwork. The lease will say who repairs the roof, walls and structure, and you will normally need the freeholder’s licence before altering anything structural, such as a chimney breast that may support the flat above.

Questions

How can I find out exactly when my house was built?

Your conveyancing papers or title deeds may give a date. Old Ordnance Survey maps, your council’s planning records and local archives can narrow it down. Neighbours with the same house type often know.

Does my 1930s house have cavity walls?

It may or may not. Cavity walls became common between the wars, but many 1930s houses were built with solid walls. Check the brick pattern or measure the wall thickness at a window.

Get a quote

Describe the project and where it is. We’ll reply to arrange a visit, then send an itemised written quote.

  1. We reply within 2 working days
  2. We visit and look at the project properly
  3. You get an itemised, provisional quotation

Rather talk it through? Call or WhatsApp Lee on 07875 545032.

Photos help. Send them from the contact page or reply to our email with them.

What’s it about?

We reply to every enquiry within 2 working days. Your details are only used to reply about this project.

Enquiry sent

Thanks, that’s with LR Building

We reply to every enquiry within two working days.

Not heard back by then? Call or WhatsApp Lee on