In short
- Ground, paths or patios raised to or above the damp-proof course let moisture bypass it.
- Guidance is to keep the outside ground at least 150mm below the damp-proof course.
- Blocked air bricks, leaking gutters and broken downpipes cause the same kind of damp.
- Fixing the cause outside is usually cheaper and more lasting than treating the wall.
How high ground levels cause damp
A damp-proof course is a barrier built into the wall just above ground level. It only works if the ground outside stays below it. Over the years, ground levels creep up: a new patio laid on top of the old one, a path resurfaced, soil banked up in a flower bed against the wall.
Once the ground is level with the damp-proof course or above it, moisture can go round it. Rain also splashes back off hard paving onto the wall above. The result is damp at the bottom of the wall inside, often with tidemarks, salts and crumbling plaster, which looks very like rising damp.
Many Victorian and older houses have no damp-proof course at all, or an early one in slate or engineering brick. For them, a high ground level is just as harmful, because the wall was designed to dry out above a ground level that has since risen.
How high should the ground be?
Building regulations for new work require a damp-proof course at least 150mm above the adjoining ground. Historic England gives the same rule of thumb for older houses: keep external ground at least 150mm below any damp-proof course, or below the internal floor level where there is none.
Look for a line of slate, a darker course of brick or a thin strip of bitumen in the mortar joint near the bottom of the wall. Then count the brick courses down to the ground. Two courses of standard brick is roughly 150mm.
Other causes at the foot of the wall
- Air bricks blocked by soil, paving or planting, so the space under a suspended timber floor is no longer ventilated.
- Leaking or overflowing gutters, hoppers and downpipes soaking the same patch of wall.
- Blocked gullies and drains spilling water against the wall.
- Render or plaster carried down over the damp-proof course, bridging it.
- Hard cement render or pointing trapping moisture in a solid wall.
A real example
One of our customers had damp along the bottom of their walls. Several companies had looked at it and recommended damp-proof injection. When we visited, the cause was outside: the ground levels had been raised above the damp course. Putting the ground right dealt with the problem at its source, without chemicals in the walls.
It is a common story. Historic England’s advice is to deal with the obvious defects first, such as ground levels, gutters and ventilation, then give the wall time to dry before deciding whether anything more is needed.
What the fix involves
Usually, lowering the ground in a strip along the wall to at least 150mm below the damp course. Where paving cannot be lowered, a narrow channel or French drain along the foot of the wall, filled with gravel and falling to a drain, can take water away from it.
At the same time, air bricks are cleared or reset above ground, gutters and downpipes are repaired, and any render bridging the damp course is cut back. Inside, salt-damaged plaster may need replacing once the wall has dried, ideally in a breathable lime plaster.
Take care not to dig below the level of the foundations. Shallow Victorian footings should not be undermined, so the work should be done by someone who knows how older houses are built.
