In short
- Gauged brickwork uses soft bricks cut and rubbed to exact sizes and laid with very thin lime joints.
- Tuck pointing makes ordinary brickwork look gauged, using a coloured mortar and a fine raised line.
- You see gauged work most often in flat arches over Georgian windows and doors.
- Both are repaired in lime, by bricklayers trained in the traditional methods.
What is gauged brickwork?
Gauged brickwork is built with soft, fine-textured bricks known as rubbers. They are fired at a low temperature so they can be cut and rubbed down to exact shapes, then laid with joints of a millimetre or two in lime putty.
In the early eighteenth century whole fronts were sometimes built this way. It was expensive, and by the Georgian period it was mostly kept for the parts that showed: flat and curved arches over windows and doors, aprons below windows, and decorative details.
How to recognise gauged work
- Window and door heads in a smooth, even brick, often a brighter red or orange than the walls around them.
- Joints so fine they are barely visible.
- Bricks tapered to fan out across a flat or curved arch, each one cut to fit.
- Crisp, sharp edges and a slightly polished face from the rubbing.
What is tuck pointing?
Tuck pointing developed in England in the late eighteenth century as a cheaper way to get the look of gauged work on ordinary bricks. The joints are filled flush with a mortar coloured to match the bricks, which hides their irregular edges. A groove is then cut along the centre of each joint and a thin, neat ribbon of lime putty, usually white, is pressed into it and trimmed.
From the street the result is a wall that appears to be laid with perfectly straight, fine joints. It was widely used on London terraces through the nineteenth century and into the early twentieth.
Repairing gauged brickwork and tuck pointing
Neither is work for a general builder. Damaged gauged arches can be taken down, the rubbers recut or replaced, and the arch rebuilt with joints as fine as the original. Tuck pointing has to be raked out by hand, the coloured mortar matched to the bricks, and the ribbons run straight and even across a whole elevation.
All of it is done in lime. A cement repair on soft rubbers will damage them, and a cement ribbon looks heavy and wrong.
On a listed building, or in a conservation area, the council may also want to see samples or a trial panel before the work goes ahead.
Who to ask
Look for a bricklayer who has done this work before and can show you examples. We are bricklayers by trade: Lee Ricketts, who runs the firm, served a five-year apprenticeship and holds the City & Guilds Advanced brickwork qualification. We have carried out gauged brickwork and tuck pointing on London’s period houses for decades, and from 1980 to 1991 we were an approved restoration contractor to four London borough councils.
